• About Us
  • Certs
  • Events & Updates
  • Contact

Signature Products

iprime

iprime™
CAS NO. 67-64-1

Applications

iprime™ thermoplastic primer is an acetone based, high performance clear acrylic coating, to be applied as a primer for 100% solid thermoplastic traffic paints and other solvent-based traffic paints. This product will improve thermoplastic adhesion to concrete roadways and will also serve as a vapor barrier. Aged asphalt roadway surfaces should also be properly prepared and coated with this product prior to the application of thermoplastic striping material.

Recommended Uses

  • Concrete
  • All lane/aisle line striping, legends & symbols.
  • Asphalt
  • All markings on aged asphalt.

Environmental

Meets Federal Clean Air Act Regulations.

Advantages / Features

  • Improves the adhesion of thermoplastic to the roadway surface, especially to concrete and aged asphalt.
  • Excellent moisture barrier.
  • Excellent shelf life.
  • Can be applied by spraying, brushing or rolling.
  • No thinning for application.

Surface Preparation

Substrates must be dry and free of dirt and grease and loose debris.New Asphalt and Concrete must be aged for at least 30 days and cured properly and free of any laitance before paint is sprayed. Please get an expert opinion before spraying hard to stick surfaces or for problematic conditions.

Application Equipment

Each paint has its own thickness and viscosity which can be further affected by temperature. Please check the proper pump pressures, tip sizes, atomizing pressures that are best suitable to get the most efficient spray pattern for the correct mil thickness and width of line for each project.

Application Instructions

  • Do not apply when the temperature is below 50°F and less than 80% humidity.
  • This product can be sprayed, brushed or rolled.
  • Spray with a low pressure or airless system.
  • This product comes ready mixed. Thinning is not recommended.

Mixing

No mixing is required.

Clean Up

Immediately clean all equipment after use. We recommend using Acetone for clean up.

Safety Precautions

  • For industrial use only. Not for residential use.
  • Avoid contact with eyes and skin.
  • Do not take internally. If swallowed get medical attention immediately.
  • Contents are flammable - keep away from heat and open flames.
  • Keep out of reach of children.
  • Use only with proper ventilation.
  • Clean hands thoroughly after using.

Safety precautions must be strictly followed during storage, handling and use. Please refer our SDS for more information.

Storage

Store containers tightly closed in a dry and cool place, at temperatures below 86 ºF (30 ºC), away from any source of fire or sparks. Hazardous. Highly flammable. Use proper grounding protocol. For professional use only.

Shelf Life

Thermoplastic Primer is best utilized within 6 months of delivery but remains usable for 12 months.

Coverage

About 300 square feet per gallon at recommended wet film thickness of 1-2 mils.

Packaging

  • 5 gallon pail
  • 55 gallon drums

UN 1263
Paint, 3, II

For Chemical Emergency such as spill, leak, fire exposure or accident, please call CHEMTREC day or night. DOMESTIC NORTH AMERICA: 1-800-424-9300

iprime warnings
  • Obtain special instructions before use. Do not handle until all safety precautions have been read and understood.
  • Avoid breathing dust/fume/gas/mist/vapors/spray. Use only outdoors or in a well-ventilated area.
  • Keep away from heat/sparks/open flames/hot surfaces. No smoking. Keep container tightly closed.
  • Ground/Bond container and receiving equipment. Use explosion-proof electrical/ventilating/ lighting /equipment.
  • Use only non-sparking tools. Take precautionary measures against static discharge.
  • Wear protective gloves/eye protection/face protection.
  • Wash thoroughly after handling. Do not eat, drink or smoke when using this product.
  • If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower.
  • If swallowed: Call a poison center/doctor if you feel unwell. Rinse mouth.
  • If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists get medical advice/attention
  • If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a poison center/doctor if you feel unwell.
  • If exposed or concerned: Get medical advice/attention.
  • STORAGE: Store in a well-ventilated place. Store locked up. Keep cool. Store containers tightly closed in a dry and cool place, at temperatures below 86 F (30 C), away from any source of fire or sparks. Dispose of contents/container in accordance with local/regional/national/international regulations.

Integrated Chemical Specialties, a division of ITS USA strives to provide our clients with the highest quality, competitively priced product with exceptional customer service and experienced logistical support.

Product Brochure


Can't find what you're looking for? Get in touch.

Disclaimer: The information above is believed to be accurate and represents the best information currently available to us. There are no warranties which extended beyond the information in the TDS. Integrated Chemical Specialties, a division of Integrated Traffic Systems USA warrants this product to conform to its own specifications. Integrated Chemical Specialties, a division of Integrated Traffic Systems USA liability on this warranty is limited to the return of the purchase price of this product. The buyer assumes all risks and liability resulting from the use of this product. Integrated Chemical Specialties, a division of Integrated Traffic Systems USA neither assumes nor authorizes any person to assume for it any other liability in connection with the sale or use of this product. We make no warranty of merchantability or any other warranty, express or implied, with respect to such information, and we assume no liability resulting from its use. Users should make their own investigations to determine the suitability of the information for their particular purposes. In no way shall Integrated Chemical Specialties, a division of Integrated Traffic Systems USA will be liable for any claims, losses, or damages of any third party or for lost profits or any special, indirect, incidental, consequential or exemplary damages, howsoever arising, even if Integrated Chemical Specialties, a division of Integrated Traffic Systems USA has been advised of the possibility of such damages. Request a SDS if needed. Note: Products protected by valid patents are not offered for sale in countries, where the sale of such products constitutes a patent infringement. The Liability for patent infringement is exclusively to be understood as buyer’s risk. Products currently covered by valid US Patents are offered for R&D use in accordance with 35 USC 271(e)+A13(1)

5850 San Felipe St., 5th Floor, Houston TX 77057 | United States | 713-337-0152 | Privacy Policy | Terms and Conditions